INSTALLATION TUTORIAL
1.Remove the car roof
Remove the roof of the car first(Overturn Copilot or seat,remove it from the back door)
2.Drill holes
you can use the pen to draw the point ,then use a 0.5mm-1.5mm twist drill bit to drill holes.
lf you want to make complex patterns, such as stars, galaxies, etc., you can paste a pattern on the back of the ceiling then Punch holes according to the pattern . Simple patterns can be directly Just draw holes in the ceiling.
3.Insert fiber
4.Fixed fiber
Use hot melt glue or kafuter K-5905 glue to fix.
5.Straighten the fiber
Straighten the optical fiber lines(ens of small bundles), and the concentrated parts can be rolled with black electric tape so tha tthey will not be scattered.
6.Stick sponge or leather
Stick sponge or leather to isolate the iron sheet to extend the life of the optical fiber.
7.Cut the fiber
Cut off the excess fibers in thecar, usually cut it flat to the roof.You can also cut the fiber after installing the roof.
8.Electrical connection
The power supply can be connected to the cigarette lighter plug，low beam, driving light, ACC, and the required power supply voltage is 12V. The LED light source can be hidden in the C-pillar or the trunk. Finally, Put the car roof back on .
